(thank goodness.what a disaster that was) if you offset the clarifier to say 28.0013.when you step up or down to the next channel its is 28.011. etctetc…not like the fucked way the at5555 was….įirst impressions.i like it (more defined when i can actully talk to The upside is the clarifer does not remember the last setting for the channel. (I think the AT5555 have this trouble too when the power gets cranked up but have yet to hear of a rig dying from it.) The tx reg and audio amp chip are…it needs a bit of alloy added to sink the The down side is the inside of the rig gets real hot.not enuff heatsink where Its showing all the right numbers…just need to try on air to see if it has thatĪs a note the inside seems similar to the new sryker SSB rig. Here today …and I dont have 11m on the 8900 as yet!….but on the signal gen Is a little talker this rig…rx is spot on…no one around as we have a storm
Gain for am/fm (the radio has a mic gain on the menu not a front panel pot) …it Ssb.10 carrier am/fm…the fm dev is the best i have seen on any 10m rigĪdjustable to +/-6khz!.now set at +/-2.5khz (5khz dev)….it has a internal mic OK.have popped the lid on the cre…factory they are 25 wattsssb.12-13 wattsĬarrier am/fm …have worked out all of the internal adjustments…now 50 watts
#Tuning a cre 8900 software
(I sent him the software a few days ago!) No software with 8900.only cables…stuck on 10m band grrr. The cre8900 is here and the browning mkIII Bottom line.out of the box.he is impressed…if you are into FM this is your baby! Photos to follow…. Excuse the language and the brevity but Mike also got an old Browning 3 in for the museum at the same time and and things with lots of volts and valves seems to “yank Mikes crank” a bit more than a mosfet final these days….Unabridged and unashamed….Photos to follow and he will have it up on 11m by the time he takes the photos. The radios are is stock on the Yeticomnz web site. Well despite the weird name the radio seems quite good according to Mike’s early once over.
0 kommentar(er)
